by Alicia Guarasci Alicia Guarasci

Used Stainless Steel Cabinet Washer

Used Stainless Steel Cabinet Washer for sale. This unit includes the following features:

  • 31” diameter,  36” height
  • Closed washing chamber constructed of 10 and 12ga stainless steel
  • Swing out door
  • Rotating turntable with positive engagement drive system
  • Vertical wash pump
  • Electric heating element
  • Stainless steel wash nozzles
  • Low water shut off
  • Forklift access from front of machine
  • Chip basket
  • NEMA 12 rated electrical enclosure
  • Voltage: 208 V, 3 phase
  • Frequency: 60 Hz
  • Usable turntable diameter: 31 inches
  • Usable working height: 36 inches
  • Material housing: stainless steel
  • Turntable rolls out for easy access
  • Weight capacity: 1,000 pounds (with centered load)
  • Tank capacity: 125 gallons (approx.)
  • Pump size: 5 HP (cast iron)
  • Pump output: 58 PSI at 89 GPM
  • Electric heat: (2) 9 KW heaters
  • 5HP regen blower
Used Stainless Steel Cabinet Washer

Features Included in Base Price:


STAINLESS STEEL CONTAINMENT RING

A metal ring that sits on the turn table to help keep small parts from falling off in the chip basket during the wash cycle

CT-200SS – CHIP TRAY

The chip tray consists of stainless-steel tray, which is mounted under the turntable, diverts all of the sprayed solution to a central point in the tank access area where it is forced to flow through an easily removable, stainless steel, perforated basket.

AW-100 – AUTOMATIC WATER FILL

Designed to maintain a consistent level, the automatic water fill consists of an adjustable, 1” diameter, stainless steel float switch, which is electrically wired to a brass solenoid valve. The brass solenoid is 3/4 of an inch National Pipe Thread taper, and is connected to the customer’s water supply. The float switch is mounted inside a water dam constructed on a mild steel frame.

SE-200 – STEAM EXHAUST SYSTEM

200 CFM motor driven draft inducer with an ON and OFF switch on the control box.

SO-100SS – LOW WATER SHUT OFF

A low water shut off with an adjustable 1” diameter, stainless steel float switch that is mounted above the heater. In case of a low water condition, the low water shut off will turn off the heater and/or pump circuit(s) to protect the heater and the pump.

BL-5, REGENERATIVE BLOW-OFF SYSTEM

5HP regenerative blower that creates 200 cfm of air flow at a pressure of 40 inches of water column that is directed through up 30” of air knife located in the spray area.  The air knives wipe the solution from the parts with a curtain of air as the processed part passes the air knife. The temperature of the air flow created by the blower will be approximately 40 degrees F above ambient temperature.  This system is equipped with a vacuum gauge, pressure gauge, and an air intake filter. This system is recommended for removing solution from parts that have relatively flat surfaces and minimal voids. The air knives are stainless steel and the support mechanism in contact with the cleaning solution will be mild steel.   

 

UPGRADE TO ALL WETTED SURFACES STAINLESS STEEL (SS2)

COMES WITH A LIMITED 30 WARRANTY ON PARTS ONLY

MACHINE WILL BE TESTED PRIOR TO SHIPPING

For purchasing information, email sales@blast-wash-systems.com or Contact Us.